Hiraga Machinery Mfg.Co.,Ltd.

2P Banding Machine

This device takes workpieces produced and fed on a continuous basis, turning the printed section on the surface to the outside and carrying out banding with paper bands to combine two workpieces in a single set. It then pastes cellophane tape on the sets and sends them to the next process.

Features
●	Because the timing is obtained with mechanical mechanism, stable movements of the individual units are systemized.
●	The bening section features a stepping motor to drive the bend supply. A dancer roll controls the fixed tension feed for high accuracy in cutting measurements.
●	Commercially available 18 mm cellophane tape can be used.
●	The tape cutter uses a special process so that sticky materials do not adhere to the blade even during continuous cutting.

Specifications

●

Packaging dimension & capacity

Application A:	L115xW75xH62mm±2(overwrap）60packs/min. Automatic feed
Application B:	L115xW70xH74mm±2(pillowwrap）30packs/min. Manual feed
Application C:	L117xW72xH40mm±2(pillowwrap）30packs/min. Manual feed

●

Required power

3kW(AC200V three phase,50/60Hz)

●

Compressed air consumption

200Nl/min.(5kg/c㎡G)

●

Paper band

W50mm

●

Cellophane tape

W18×L30mm

●

Machine dimensions

L1500xW1450xH1800mm

click here!
An Overview of Products